Electric Drill
An electric drill is a motor-driven hand tool that spins a chuck-held bit to bore holes and drive fasteners. It is the most widely used power tool on a construction site, available in corded and cordless versions.
Fonctionnement
An electric motor drives the chuck through a reduction gearbox, and a trigger modulates speed from zero up to roughly 2,300 RPM on models in this class. A keyed or keyless chuck clamps the bit shank, and most drills add a clutch that slips at a set torque to avoid over-driving screws. Hammer-drill variants add a percussive mode for light masonry drilling.
Types et variantes
- Drill/drivers
- General-purpose cordless drills with an adjustable clutch for drilling and screwdriving.
- Corded drills
- Mains-powered drills for sustained drilling without battery limits.
- Hammer drills
- Dual-mode drills that add percussion for occasional holes in masonry.
- Right-angle drills
- Compact heads that drill between studs and joists where a standard body cannot fit.
Spécifications clés
| Spécification | Plage typique | Signification |
|---|---|---|
| No-load speed | 18–2,300 RPM | Higher speed suits small bits in wood; lower speed with more torque suits large bits and metal. |
| Weight | 1.8–10.6 lb (0.8–4.8 kg) | Lighter drills reduce fatigue overhead; heavier models generally carry stronger motors. |
| Overall length | 6.8–14.6 in (173–370 mm) | Shorter bodies reach into cabinets, joist bays, and other tight spots. |
Comment l'industrie le dimensionne
The rental industry bands electric drills by chuck diameter. A 3/8 in chuck handles driving screws and pilot holes in wood and light metal. A 1/2 in chuck accepts hole saws, self-feed bits, and paddle mixers and is the everyday jobsite drill. Drills with 3/4 in and larger chucks—usually right-angle—run big augers and self-feed bits punched through joists and studs.
Applications
- Pilot holes and fastener driving in framing and finish carpentry
- Drilling steel brackets, panels, and equipment during fabrication and repair
- Hardware, hinge, and fixture installation
- Mixing small batches of paint or thinset with a paddle attachment
Sécurité et opération
- A binding bit transfers torque to the wrist; larger drills should be run with the side handle fitted.
- Corded drills used outdoors or in damp locations require GFCI-protected circuits.
- Remove the chuck key before starting, and keep loose clothing clear of the rotating chuck.
Normes et certifications
- OSHA · 29 CFR 1926.302(a)
- Electric power-operated tools must be double-insulated or grounded.
- UL · UL 62841
- Safety standard for hand-held motor-operated electric tools.
Questions fréquentes
Corded or cordless?
What chuck size is standard?
Can an electric drill bore concrete?
Équipements connexes
Parcourir par fabricant
Sources
Chaque spécification est vérifiée par rapport aux données publiées par le fabricant, avec la source liée pour référence.
Tous les modèles
133 modèles · Page 3 sur 3 · Chaque spécification citée à la source