CAT CLASS: HQ-10099

Up to 80 in Ride-On Power Trowel

Up to 80 in Ride-On Power Trowels are two-rotor machines designed for warehouse bays and mid-size commercial slabs where a walk-behind trowel would be inefficient but the largest quad-rotor units are unnecessary. This size class represents the entry point on the ride-on trowel ladder, offering operator-carried productivity on moderate floor areas. Models in this band typically provide a total finishing path width of 63 to 74 inches across both rotors.

Modelos

Marcas

Cat classes

Elija una clase de tamaño — la capacidad y el alcance varían en la gama.

Especificaciones clave

Especificación	Rango típico	Qué significa
Total Path Width	63–74 in (160–188 cm)	Combined coverage of both rotors in a single pass; defines productivity per hour on slab.
Rotor Configuration	Dual rotor	Two independent finishing rotors for balanced coverage and operator visibility.
Machine Class	Ride-on	Operator sits on the machine, reducing fatigue on projects larger than walk-behind capacity.

Cómo elegir

This size is appropriate for warehouse loading bays, retail tenant build-outs, and industrial floors in the 5,000 to 20,000 square foot range where operator fatigue and schedule constraints make walk-behind trowels impractical. The dual-rotor layout offers good maneuverability in column grids and around embedded anchors. For large distribution centers, tilt-up warehouses, or any slab exceeding 25,000 square feet, the 80+ in Ride-On Power Trowel with quad-rotor design delivers higher production rates and is the preferred choice.

Lo que maneja este tamaño

Warehouse loading dock slabs and truck aprons
Retail shell spaces and tenant improvement floors
Light industrial production areas with moderate square footage
Commercial kitchen and food processing floors
Parking structures with confined bay widths
School gymnasiums and multi-purpose rooms

Seguridad y operación

Operator must maintain clear sightlines to both rotors and surrounding workers; dual-rotor layout requires attention to front and rear finishing zones
Emergency stop controls should be within immediate reach from the operator seat; familiarization with shutdown procedures is essential before operation
Concrete surface must support machine weight during finishing; premature loading can damage slab and compromise flatness
Protective guards around rotors and moving parts prevent contact with blades spinning at high RPM during floating and finishing passes

Transporte y logística

Typically loaded onto tagalong or tilt-deck trailers; most models fit within standard 102-inch transport width
Dual-axle utility trailers with 7,000–10,000 lb capacity commonly used for single-machine transport
Some units feature fold-down operator stations or removable components to reduce transport height

Alimentación

Gasoline or diesel engines in the 23–35 horsepower range provide independent power for each rotor and hydraulic systems
Machines carry onboard fuel tanks; typical runtime on a full tank ranges from 4 to 8 hours depending on load and finish stage
No external electrical connections required; self-contained power suitable for sites without utility hookups

Preguntas frecuentes

What slab size justifies a ride-on trowel over a walk-behind?

Industry practice generally shifts to ride-on equipment on slabs above 5,000 square feet, where operator fatigue and schedule efficiency favor seated operation. Project-specific factors such as pour sequence, finish specification, and labor availability also influence the decision.

How does path width affect production rate?

A machine with 70-inch total path width can finish approximately 10,000 to 15,000 square feet per hour under typical conditions, though actual rates depend on concrete set time, number of passes required, and operator experience.

Can this size handle edge work near walls and columns?

Dual-rotor machines in this class typically leave 12- to 18-inch margins at perimeters and columns that require hand troweling or walk-behind equipment to meet edge flatness specifications.