CAT CLASS: HQ-10205

Up to 1,500 lb Compact Track Loader

The Up to 1,500 lb Compact Track Loader represents the smallest class of tracked skid-steer machines, sized by rated operating capacity. This class prioritizes narrow width and low ground pressure for turf-sensitive sites and tight residential access where larger loaders cannot operate. It is the entry point on the compact track loader ladder, below the 1,500–2,200 lb class.

132

Modèles

Marques

Cat classes

Choisissez une classe de taille — la capacité et la portée varient selon la gamme.

Spécifications clés

Spécification	Plage typique	Signification
Rated operating capacity	227–1,075 lb (103–488 kg)	Maximum safe load the loader can carry at full lift height; defines the size class.
Operating weight	854–2,790 kg (1,882–6,151 lb)	Machine weight affects ground pressure and determines trailer requirements.
Hinge pin height	81–168 cm (32–66 in)	Maximum height the attachment plate reaches; determines truck-loading and overhead clearance.

Comment choisir

This size class is appropriate for residential landscaping, backyard grading, and work requiring passage through gates, between structures, or across established turf where ground disturbance must be minimized. The low ground pressure of track systems in this weight range permits operation on saturated soil and finished lawns. For general construction grading, material handling above half a cubic yard, or commercial site work, the 1,500–2,200 lb Compact Track Loader provides greater lift capacity and reach without sacrificing substantial maneuverability.

Ce que cette taille peut gérer

Backyard grading and leveling between houses or through 36–48 inch gates
Turf preparation and topsoil spreading on residential lots
Light excavation and trenching for irrigation or drainage on established lawns
Paver and retaining-wall installation in tight courtyards
Landscape material placement where truck access is impossible
Snow removal on paved paths and narrow driveways

Sécurité et opération

Rollover protective structures (ROPS) and seatbelts or restraint bars standard; operator must remain seated or restrained during operation
Low center of gravity and wide track stance reduce tip risk, but rated operating capacity must not be exceeded on slopes
Ground pressure advantages require awareness of underground utilities; tracks distribute load but can still damage shallow lines
Attachment changes require hydraulic pressure relief and the machine must be on level ground with attachment lowered

Transport et logistique

Light utility trailers or single-axle equipment trailers; machines in this class typically weigh under 3,000 kg
Many models transportable behind half-ton pickups when trailer weight is accounted for
Walk-on loading via ramps; hinge pin heights under 170 cm allow clearance in enclosed trailers

Alimentation

Gasoline or diesel engines; gasoline common in smallest models for reduced weight and cost
Fuel tanks typically 20–40 liters, supporting half- to full-day operation depending on load cycles
Self-contained engine drives hydraulics for tracks and attachment

Questions fréquentes

What is the practical width for gate or alley access with machines in this class?

Most models in this size range measure 90–120 cm (35–48 inches) wide, allowing passage through standard residential gates and between closely spaced structures where wheeled skid steers cannot fit.

How does lift capacity in this class compare to a compact wheel loader?

Compact wheel loaders typically begin around 1,500 lb capacity, so this track loader class operates below that threshold. The tracked design trades outright lift for traction and ground protection on soft or sensitive surfaces.

What bucket size typically pairs with machines in this capacity range?

Bucket widths of 90–120 cm (36–48 inches) and volumes of 0.1–0.3 cubic meters (roughly 3–10 cubic feet) match the lifting and stability limits of this class without exceeding rated capacity when loaded with soil or gravel.

Comparer les modèles populaires

Chercher par spécification →

Normalisé aux mêmes unités. Un tiret signifie que la valeur n'a pas été publiée.

Modèle	Poids en service	Profondeur d’excavation max	Portée max	Puissance moteur
Toro Dingo TX 427 Track Loader, Narrow	1,883 lb (854 kg)	-	1.8 ft (0.5 m)	-
Toro Dingo TX 1000 TURBO Track Loader, Wide	2,791 lb (1,266 kg)	-	-	-
Toro Dingo TX 427 Track Loader, Wide	1,991 lb (903 kg)	-	-	-
Kubota SCL1000	3,034 lb (1,376 kg)	-	-	25 hp